Amer Networks SS2GR50I Guía de instalación descargar pdf (Pagina 19)

Installation Guide

2-7

3. Power on the switch and the character terminal. Configure the switch through the

character terminal.

2.3.3 SFP Transceiver Installation

SS2GR50i/26i series provides multiple 1000Mb SFP transceiver slots. The procedure for

installing the SFP transceiver is shown below:

Step 1: Put on a ESD wrist strap (or antistatic gloves)

Step 2: Insert the SFP transceiver to the guide rail inside the fiber interface line card. Do

not put the SFP transceiver up-side-down.

Step 3: Push the SFP transceiver along the guide rail gently until you feel the transceiver

snap into place at the bottom of the line card.

Note: the SFP transceiver is hot swappable.

Caution

Do not stare directly into the 2 fiber bore in the SFP transceiver when the switch is in

operation, otherwise the laser may cause serious damages to your eyes.

2.3.4 Copper Cable/Fiber Cable Connection

Copper cables should be connected as below:

Step 1: Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the switch

copper cable line card;

Step 2: Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of some

other device;

Step 3: Check all status indicators for the corresponding ports; a lighted LED indicates

that the link has been established, otherwise the link is not ready and the cable

should be examined.

Caution!

Please verify the sign above the port to ensure using the right port. Connecting to wrong

ports might damage the switch.

Fiber cables should be connected as below:

Step 1: Remove the protective plug from the SFP/XFP fiber transceiver bore; Remove the

protective cap from one end of the fiber cable. Keep the fiber end clean and neat.

Step 2: Attach one end of the fiber cable to the SFP/XFP transceiver, and attach the other

end to the transceiver of the corresponding devices. Note: The SFP/XFP

transceiver’s TX port should be connected to the RX port of the corresponding

device, and vice versa.

Step 3: Check the fiber port status indicator, a lighted LED indicates that the link has been

1 2 ... 14 15 16 17 18 19 20 21

Sin comentarios

Amer Networks SS2GR50I Guía de instalación Pagina 19