Amer Networks C1110-32 Guía de usuario descargar pdf (Pagina 11)

5. Switch computer power on. If the BIOS section of

your computer’s boot program is Plug-and-Play

compliant, then at power-up the BIOS will

automatically configure any newly installed the

Gigabit Ethernet Card.

NOTE: Due to a fault in some Plug-n-Play BIOS

programs, it happens occasionally that a newly

installed adapter is assigned an Interrupt

Number which is already assigned to another

device. In such a case, the conflict of Interrupt

Number will cause faults in the behavior of

both devices. Then it is necessary to run the

CMOS Setup utility, and manually assign a

non-conflicting Interrupt Number.

Connecting the Network Cable

Four pair of Cat.5 UTP or STP cable with RJ-45

connector is required for the 32-bit PCI

10/100/1000Mbps Gigabit Ethernet Card. You can use

standard or crossover cable to connect the switch MDI-

X or MDI-II port, because the 32-bit PCI

10/100/1000Mbps Gigabit Ethernet Card will adjust the

correct signal automatically.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Sin comentarios

Amer Networks C1110-32 Guía de usuario Pagina 11